Task 6 - Produce Samples of Mini Beasts Design

These images show all my 3D models that I had made in the given amount of time. 

 This image shows my Clay Model of my bug. It has the body and the wings and legs that are made out of wire. I also added patterns to the bug so it does not look boring and bland. The clay at first was hard to use but it was very easy to get used to it.

This image shows a 3D model of one of my bug designs, and it is made out of masking tape and newspaper. In order to make the legs I had to attach wire to the body and then surround the wire with masking tape. This too was difficult as the newspaper kept falling apart. 

This final image shows a 3D Model I made that is made solely out of just wire. This was the most difficult task as the wire could fall out of place easily if not attached properly and the wire could also very easily injure you. It was also difficult because it was hard to bend the wires appropriately to match that of my actual design and the legs stayed loose so they were easy to detach.